Subscriber Outbound Routing Configuration

To set up outbound routing, go to "Virtual PBX" >> "Settings" >> "Extension numbers" >> the "Outbound routing" tab.

For outbound routing of a subscriber, the following parameters are set:

1. Default number;

2. Routing type:

   • Disabled

   • Region of called number
     For more details, see ”Region of called number”.
     For connecting this option, see “How to enable Geo-routing”.

     ⚠️ Attention! The option must be enabled both on the subscriber and on the phone numbers that participate in the routing. See ”DID numbers”. If the option is not enabled in the phone number settings, this number will not be used for auto-replace by geography.

      

   • Carousel
     For more details, see “Carousel”.
     To enable this option, contact a manager or support.

3. Allowed call destinations:

   • International — international outgoing calls are disabled;
   • Local distance — international and long-distance outgoing calls are disabled;
   • Local mobile — mobile, long-distance and international calls are disabled;
   • Local — any outgoing calls are disabled, except for internal ones.
     

     ⚠️ Attention! For the subscriber to be able to make calls to the allowed directions, these directions must also be enabled on the phone number through which the call is made. See ”DID numbers”.

      

4. Limiting expenses on paid outgoing traffic: "Daily traffic limit" and "Monthly traffic limit". For more details, see “Cost control”. Move the slider to the right and enter the limit value ("0" - paid outgoing calls are disabled). To connect this option, contact a manager or support.

See also:

DID numbers routing Configuration